Infocus IN2100 Manuel d'utilisateur télécharger pdf (Page 4)

5-10 sec.

source

Turn on projector and source

Connect the power cord to the

projector and to an electrical

outlet

The power light on the projector will light amber.

Slide open the lens cover

Turn on the projector

Touch the power light (or press power on the remote).

The power light will start blinking green.

Wait for the lamp to warm up

After a few seconds, the power light will stop blinking

and turn green. It can take a minute for the lamp to

reach full brightness.

Warning: Do not look directly into the lens while

the projector is being used.

Turn on computer or other source

You may need to press a specic key combination to activate

your laptop’s external video port. On most laptops, hold

down the FN key while pressing a key labeled CRT/LCD, LCD/

VGA, a monitor icon , or similar. Key combos for popular

models:

Apple F7 HP/Compaq Fn+F4 or Fn+F6 Sony Fn+F7

Dell Fn+F8 IBM ThinkPad Fn+F7 Toshiba Fn+F5

Fujitsu Fn+F10

Complete laptop activation chart at www.infocus.com/support

Important: If there is still no video, restart your

computer (rst make sure it’s connected to the

projector and the projector is turned on).

Change source if needed

If needed, press source (on the projector or remote)

to view the source. You may have to press it more than

once.

1 2 3 4 5 6 7 8

Pas de commentaire

Infocus IN2100 Manuel d'utilisateur Page 4